How do I exit the LightRules 3.X Screen Saver?

Overview

When a monitor and keyboard are connected to a LightRules Appliance (LRA) running LightRules 3.0 or newer, pressing CTRL - ALT - DELETE on the keyboard will enter into the "XScreenSaver 5.34" mode seen below.

Instructions

To exit out of this mode and back into the normal LightRules Web Application, you can enter the following credentials:

Username: lruser

Password: DigitalLumens

Alternatively you can exit the screen saver by restarting the LRA using the power button.

• Related Articles

• Reset LightRules User Password

  Overview If you cannot login to LightRules there are multiple methods to reset your password. The following instructions assume you can access the LightRules login screen. Instructions Start by scrolling to the gray bar at the bottom of the ...

• Create a LightRules Backup Drive

  Overview The following instructions detail how to create a LightRules Appliance Backup USB Drive for LightRules versions 2.8.X or higher. Disclaimer Please follow these instructions precisely as deviation from them may result in improperly configured ...

• Troubleshooting LightRules Gateways

  The following guide will provide troubleshooting steps that will not only remedy several issues that can arise, but expedite the support process if initial troubleshooting is unsuccessful. Gateway Status The first step is to understand the status of ...

• LRA Emergency Mode - root@lightrules

  Overview File system errors may cause a LightRules Appliance (LRA) to be unable to boot properly. When a LRA to be unable to boot properly, error messages will appear on a monitor such as "warning mounting unchecked fs, running e2fsck is recommended" ...

• LightRules Documentation

  The Digital Lumens LightRules system was discontinued in 2017 and reached end of life in late 2022. SiteWorx does not provide support for the LightRules platform. The legacy LightRules Documentation site is available at ...